Ground anchors hold retaining walls and slopes back, often replacing props that get in the way of the work.

A ground anchor is a steel tendon fixed deep in firm ground with grout, then pulled tight and locked off to hold a set load. This pulls a wall or slope back into the ground so it can resist the pressure behind it. Ground anchors are similar to soil nails, but they are stress tested and locked off with a residual load maintained, so they start working straight away.

Where are ground anchors used?

Ground anchors are used as an alternative to props in sheet piled excavations, whether the support is temporary or permanent, which leaves the working area clear. They are also used to support retaining walls, stabilise slopes and rock faces, restrain bored pile and diaphragm walls in deep basements, and tie back walls beside watercourses.

Temporary and permanent anchors

Temporary anchors support a wall or excavation while the work goes ahead and are not needed afterwards. Permanent anchors stay in service for the life of the structure, so they have extra corrosion protection. Which type you need depends on how long the support is required and on the ground conditions.

How ground anchors are installed

A hole is drilled through the wall or slope to the required depth. The anchor, with a fixed length bonded in firm ground, is placed in the hole and grouted. Once the grout has gained strength, the anchor is stressed with a hydraulic jack, tested to confirm that it carries the load, and locked off at the working load.

Ground anchor questions

What is the difference between ground anchors and soil nails?

Soil nails are passive and work as the soil moves slightly. Ground anchors are tensioned in advance, which suits sheet piled and deep excavations, or where very little movement is allowed. See our soil nailing page for the alternative.

Can ground anchors replace props?

Often, yes. Anchoring to the ground behind the wall can leave the excavation clear for other trades.

How do you check an anchor works?

Anchors are stressed and tested before they are locked off, so the load they carry is measured, not assumed. Standards for grouted anchors are set out in BS 8081 and BS EN 1537.

Are they removed afterwards?

Temporary anchors can be de-stressed or removed. Permanent anchors stay in place and are designed for that.